Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 92)

76
CATC M ERLIN ’ S W AND 2.00 C HAPTER 8
User’s Manual Using Merlin to Record Merlin’s Wand Traffic
Step 5
On the Applications tab, select Merlin from the list of
applications.
Step 6
Select the Default Properties tab and make sure that
“Enable Distributed COM on this computer” is checked.
Step 7
Select the Default Security tab and make sure that “Enable
remote connection” is checked.
Step 8 Click OK.
Windows NT®/2000 Operating Systems
Use this procedure to configure DCOM and accessibility properties to run a
Merlin analyzer remotely on a machine running Windows NT 4.0 or
Windows 2000. All the steps should be performed on the remote machine.
Step 1 Open the Merlin application on the remote machine in
order to register it with COM, and then close the application.
Step 2 Select Start > Run from the Windows taskbar.
The Run dialog will open.
Step 3 Enter “dcomcnfg” in the Open combo box and press OK.
The Distributed COM Configuration Properties dialog will open.
Step 4
On the Applications tab, select Merlin from the list of
applications.
Step 5
Click the Properties button.
The Merlin Properties dialog will open.
Step 6 Go to the Security tab.
Step 7
Select the “Use custom launch permissions” radio button
and click the associated Edit... button.
The Registry Value Permissions dialog will open.
Step 8
Make sure Allow Launch is selected in the Type of Access
drop-down list.
Step 9 Click Add...
The Add Users and Groups dialog will open.
Step 10 Select names from the Names list and click Add to include
them in the Add Names list.
Step 11
When all desired user names have been added, click OK.
Step 12 Click OK on each of the three dialogs that are still open.