Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 26)

10
CATC M ERLIN ’ S W AND 2.00 C HAPTER 2
User’s Manual Getting Started
• Command Generator -- A tool that allows Bluetooth
commands to be issued in any chosen sequence. If
Command Generator isn't enabled on your Merlin’s Wand
system, a License Key must be obtained from CATC
before it can be used.
• Script Manager -- A notepad-like tool for writing and
launching scripts that cause Merlin’s Wand to generate
traffic. This tool is an optional feature. If Script Manager
isn't enabled on your Merlin’s Wand system, a License
Key must be obtained from CATC before it can be used.
Note
: When switching between Profile Wizard, Command Generator and
Script Manager, all connections that have been established between
Merlin’s Wand and another Bluetooth device should be closed.
However, expert users may choose to leave the connections open. If
a connection is left open and you attempt to switch tools, Merlin’s
Wand will prompt you to close the connections. Choosing
Disconnect All will close the connections. Choosing Cancel will
leave the connections open, but some commands might not work
properly in the other tool. When switching to Profile Wizard, any
open connections must be closed.
• The Device Status window is on the
left side of the interface. It contains
two tabs: Device List and Connections.
• Device List - Displays a list
of devices that Merlin’s
Wand has discovered. It also
contains information about
the devices found, such as
the Bluetooth address, the
state, the role, the class, and
the device’s local name.
This window is open by default. These symbols in the list
indicate a device’s state: C = Connected; i = In Range.
Right-clicking on a listed device opens the Device List
Pop-Up Menu. The menu presents the following options:
Connect, Add Audio Connection, Get Device Information,
Delete, and Disconnect All. For details on using the Pop-Up
Menu, see Chapter 6, Device Search and Device List Pop-Up
Menu, on page 61.