Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 51)

35
CATC M ERLIN ’ S W AND 2.00 C HAPTER 3
User’s Manual Profile Wizard
Wand.
Once the connection is established, the Emulation Status screen will
indicate that Merlin’s Wand has an RFCOMM connection to the device.
Step 3
Click the Answer button to make an SCO connection with
the remote device.
If the connection attempt is succesful, the screen will change to indicate
that an SCO connection has been established.
Step 4 (Optional) Click the Hang Up button to close the
connection. The connection between Merlin’s Wand and the
device will terminate.
Emulate Device: Headset Audio Gateway
Merlin’s Wand can be configured to emulate a wireless device that
conforms to the Bluetooth Headset Audio Gateway profile. The following
steps show how to set up Merlin’s Wand as a Headset Audio Gateway
device and connect to it with a remote Bluetooth headset.
Step 1 Complete Steps 1-4 in Section 3.3, “Emulating Devices” on
page 30.
The Headset AG Emulation screen will open, indicating that Merlin’s
Wand has been configured to emulate a device that supports the Headset
Audio Gateway profile and is awaiting connection from a device.
Note The Speaker and Microphone Volume levels shown in the previous screenshot
reflect the volume settings on the Master device. If you adjust the levels on the
remote device, the displayed volume levels will change accordingly.
Step 2 Direct a remote Bluetooth device to connect to Merlin’s
Wand.
Once the connection is established, the Emulation Status screen will
indicate that Merlin’s Wand is currently connected to the device.
Step 3
To verify that Merlin’s Wand and the remote device are
successfully connected, speak into the microphone on one
device and listen for audio on the other.
Emulate Device: LAN
Step 1 Complete Steps 1-4 in Section 3.3, “Emulating Devices” on
page 30.