Metrohm tiamo 2.1 Manual - Manual (Page 1030)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1016 ￭￭￭￭￭￭￭￭ tiamo 2.1
Range -20.0 ... 150.0 °C
Default value 25.0 °C
5.6.5.6 CAL LOOP Conc
5.6.5.6.1 CAL LOOP Conc - Overview
Dialog window: Method ▶ CAL LOOP Conc ▶ Properties.. ▶ CAL LOOP Conc - 'Com-
mand name'
Loop command for the calibration of ion-selective electrodes, which is
used together with the command CAL MEAS Conc.
Appearance
The command has the following appearance:
Parameters
The parameters for the command CAL LOOP Conc are configured in the
following dialog window:
￭ CAL LOOP Conc - Properties
Command variables
The following command variables are generated in the method run by the
command CAL LOOP Conc and can be used in formulas under the desig-
nation 'Command name.Variable designation':
Identifi-
cation Description
.BLV Blank value calculated from the calibration
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.ENP Electrode zero point calculated from the calibration
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Command
has never been ended
.LCO Loop counter = current quantity of completed runs, both of
Repeat loops and of While loops
.LST Start time of the loop command (Date/Time)
.SLO Electrode slope calculated from the calibration