Metrohm tiamo 2.1 Manual - Manual (Page 593)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 ￭￭￭￭￭￭￭￭ 579
descending
Only equivalence points with a negative slope of the titration curve will
be recognized.
off
Equivalence point recognition is switched off.
Evaluation with measured value window (U)
[New]
Opens the dialog window Measured value # in which the parameters for
a new window can be entered (see Chapter 5.6.3.3.3.9, page 585).
[Properties]
Opens the dialog window Measured value # in which the parameters for
the selected window can be edited (see Chapter 5.6.3.3.3.9, page 585).
[Delete]
Deletes the window selected in the table.
Evaluation with volume window (mL)
[New]
Opens the dialog window Volume window # in which the parameters for
a new window can be entered (see Chapter 5.6.3.3.3.10, page 586).
[Properties]
Opens the dialog window Volume window # in which the parameters for
the selected window can be edited (see Chapter 5.6.3.3.3.10, page
586).
[Delete]
Deletes the window selected in the table.
5.6.3.3.3.7 MET U - Additional evaluations
Tab: Method ▶ MET U ▶ Properties... ▶ Additional evaluations
Figure and parameters: see DET U - Additional evaluations
Command name
Name of the command.
Input 25 characters
The following additional methods for evaluation of titration curves can be
activated and defined on this tab: