Metrohm tiamo 2.1 Manual - Manual (Page 383)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.1 ￭￭￭￭￭￭￭￭ 369
4.8.4.6 Curve properties - Measuring point list
Dialog window: Database ▶ Curves ▶ Properties curves # ▶ Options
Parameters for showing the measuring point list.
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved per
curve window and per client.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS Opt | MEAS Spec |
CAL Spec | KFT | KFC | BRC | STAT | DOS
Default value DET
Note
When the dialog window is opened, those Command type will be selec-
ted as standard which applies for the curve shown in the curve window.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be
edited.
Available columns
Shows all fields that can be displayed as columns in the measuring point list.
Displayed columns
Shows all fields that will be shown as columns in the measuring point list.
Adds the selected column to the measuring point list.
Removes the selected column from the measuring point list.
Modifies the sequence of displayed columns by moving the selected column
up and down.