Metrohm tiamo 2.1 Manual - Manual (Page 254)

4.4 Templates ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
240 ￭￭￭￭￭￭￭￭ tiamo 2.1
Selection DET pH | DET U | DET Upol | DET Upol | MET
pH | MET U | MET Ipol | MET Upol | SET pH | SET
U | SET Ipol | SET Upol | MEAS pH | MEAS U |
MEAS Ipol | MEAS Upol | MEAS T | MEAS Conc
| MEAS Cond | CAL MEAS pH | CAL MEAS
Conc | CAL Cond | MEAS T/Flow | MEAS TC
Cond | MEAS Ref | MEAS Spec | MEAS Opt | CAL
Spec | KFT Ipol | KFT Upol | KFC | BRC | STAT
pH | STAT U | DOS pH | DOS U
Default value DET pH
Autoscaling
on | off (Default value: on)
If this check box is activated, then the. In this case the fields Start value
and End value cannot be edited.
Tabs
Further properties of a template for the overlaying of curves can be set on
the following 4 tabs:
￭ x axis
Parameters for the graphical display of the overlaid curves on the x axis.
￭ y axis
Parameters for the graphical display of the overlaid curves on the y axis.
￭ Options
Options for the graphical display of the overlaid curves.
￭ Comment
Enter comment on the template.
4.4.3.2.2 Curve overlay - x axis
Dialog window: Database ▶ Tools ▶ Templates ▶ Curve overlay templates ▶ Prop-
erties
Parameters for the graphical display of the overlaid curves on the x axis.
x axis
Size
Selection of the quantity to be shown on the x axis.
Selection Command-dependent selection
Label
Freely definable axis label for the x axis. With auto the designation from the
field Size will be used.
Input 25 characters
Default value auto