Metrohm tiamo 2.1 Manual - Manual (Page 1162)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1148 ￭￭￭￭￭￭￭￭ tiamo 2.1
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
5.6.10.2.2 REQUEST - Properties
Dialog window: Method ▶ REQUEST ▶ Properties... ▶ REQUEST - Data input #
Command name
Name of the command.
Input 25 characters
Sample data request
The sample types that are not to be entered until after the determination
starts can be selected In the dialog window REQUEST - Data input #. The
dialog window Sample data request,, in which the sample parameters
selected in the command are to be queried, appears in the method run
during the execution of the command. The run is stopped until the input is
confirmed.
Note
If the run should not be stopped (for example for back-weighing in KF
titrations), the REQUEST command must be inserted in a track other than
the one with the titration command with the option Return immedi-
ately.
Sample position
on | off (Default value: off)
If this option is enabled, then the position of the sample on the rack will be
queried.
ID1 … ID16
on | off (Default value: off)
If this option is enabled, then the sample identifications ID1 … ID16 will
be requested. If other names were assigned to this variables in the START
command, these these names will be displayed in the dialog window Sam-
ple data request.