Metrohm tiamo 2.1 Manual - Manual (Page 1133)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 ￭￭￭￭￭￭￭￭ 1119
Stop determination
The determination is stopped and the next determination of the series is
started.
Stop determination and series
The current determination and the series are terminated.
[Save as template]
Open the dialog window Save result template in order to save the result
parameters as template for the creation of new results (see Chapter
5.6.8.2.6.2, page 1121).
5.6.8.2.5.3 Result - Options
Tab: Method ▶ CALC ▶ Properties... ▶ [New] ▶ [Continue] ▶ Result - Options
The assignment of the result to a common variable and/or titer can be acti-
vated on this tab.
Save result as common variable
on | off (Default value: off)
The result will be saved under the selected name as common variable if this
option is activated (see Chapter 6.8.1, page 1280). In all cases, only the
single value for this result will be saved as a common variable, even if the
statistics are enabled for this result.
Name
The result is saved as new value for this common variable.
Selection List of all the common variables defined
Note
As long as no common variable has been defined, the combo box will be
empty. The creation of common variables is described in the configuration
(see Chapter 6.8.1, page 1280).
Note
If Common Variables are used in a CALC command then they will only
be requested at the start of the determination. This means that it is not
possible to write Common Variables during a determination and then
reuse the altered value in a different formula. For this you should use
Method variables (see Chapter 2.4.3.2, page 27).