Metrohm tiamo 2.1 Manual - Manual (Page 1317)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 ￭￭￭￭￭￭￭￭ 1303
Beaker radius
Radius of the selected special beaker on the rack. If the lift is moved to the
work position then this value will be compared with the parameter Min.
beaker radius (see Chapter 7.10.3, page 1356) that can be specifically
defined for each tower. If Beaker radius samples < min. beaker
radius then a corresponding error message will appear. With off the beaker
radius will not be checked.
Range 1.0 ... 100.0 mm
Selection off
Beaker sensor
When the selected special beaker is moved to with the command MOVE
then the beaker sensor (Tower, Robotic arm) checks whether the special
beaker is present or not. With off no check will be made. For the option
Robotic arm a swing head with beaker sensor must be installed and a
suitable work position with beaker contact must be defined for the lift, as
this must move to the beaker recognition position.
With the parameter Beaker test in the command MOVE you can deter-
mine whether the determination is to be terminated if a beaker is missing
with or without the display of a corresponding message and whether the
series is to be continued or also terminated.
Selection Tower | Robotic arm | off
6.10.3.6 Editing rack properties (774)
Menu item: Configuration ▶ Rack data ▶ Edit ▶ Properties…
Rack name
Shows the name of the rack attached. If no rack is in position then "-----"
will be shown.
Rack code
Shows the number of positions on the rack in position. The rack code cor-
responds to the arrangement of magnets on the base of the rack and is read
in by the Sample Processor in order to recognize the rack. If no rack is in
position then the display will be empty.
Number of positions
Shows the number of positions on the rack. If no rack is in position then the
display will be empty.
The parameters for the attached rack are defined on the following 2 tabs:
￭ Lift positions
Defines the work, rinse, shift and special position for Tower 1.