Metrohm tiamo 2.1 Manual - Manual (Page 122)

3.3 Sample tables ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
108 ￭￭￭￭￭￭￭￭ tiamo 2.1
Stop series ([Stop])
If this option is selected, then the series is stopped before the start of the
marked line (equivalent to [Stop]).
Start the Text editor with which the message can be entered and edited.
3.3.2.5 Properties - Data import
Dialog window:Workplace ▶ Tools ▶ Sample
table ▶ New… ▶ [Sample table] ▶ Properties… ▶ Properties - Sample
table 'Name'
Dialog window:Workplace ▶ Run ▶ Determination series ▶ Prop-
erties Run window ▶ Properties - Determination series
Enabling/disabling the import of external data for sample table fields.
Note
The successful conclusion of the data import during the run will be sig-
naled by an acoustic signal (beep).
Importing from balance
on | off (Default value: off)
If this option is enabled, then external data from the selected balance will
be imported into the opened sample table. Data can be imported into the
fields ID1…ID4, Sample size and Unit.
Note
In order to be able to import sample identifications from the balance, data
export must be set accordingly at the balance (Use designations ID1,
ID2, ID3, ID4).
Balance
Selection of the balance from which data is to be imported.
Selection Device name
Selection Always accept data | Accept data only for
active window
Default value Always accept data