Metrohm tiamo 2.1 Manual - Manual (Page 418)

5.5 Tracks ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
404 ￭￭￭￭￭￭￭￭ tiamo 2.1
5.5.2.2 Normal track
Subwindow: Method
A normal track is a track that can be created manually by the user with
Paste
▶ New track... ▶ Normal track or with the icon . It starts with
a start command (see Chapter 5.6.2.3, page 422) and finishes with an end
command (see Chapter 5.6.2.8, page 427).
Normal tracks can be called up with the command CALL and entering the
corresponding name. Branching and parallel processes can be implemented
this way. A distinction is made between the following two cases when calling
up normal tracks:
￭ Sequential running normal track
If the Return immediately check box in the (see Chapter 5.6.2.3, page
422) command is deactivated, then all of the commands of this track will
be executed in sequence. Afterwards, the track sends an acknowledge-
ment to the (see Chapter 5.6.10.3, page 1151) command that did the
calling up, and the run is continued there.