Metrohm tiamo 2.1 Manual - Manual (Page 1214)

6.3 Configuration data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1200 ￭￭￭￭￭￭￭￭ tiamo 2.1
6.3.2.2 Backup configuration data manually
Dialog window: Backup ▶ Configuration ▶ File ▶ Manually ▶ Backup Configuration
File Manually
Backup target
Backup directory
Selection of a pre-defined backup directory (see Chapter 6.2.3.2.1, page
1191).
Note
Make sure that you have read and write access rights on the selected
directory.
Backup name
Selection of an existing name for the backup file or entry of a new name. If
an existing backup file is selected it will be overwritten.
Input 50 characters
Selection Backup names
Note
If the backup directory is on a network drive. the backup date should be
added manually to the Backup name because the backup date infor-
mation is not available when the directory is restored.
[Start]
Start manual backup of complete configuration database (including method
groups and methods).
6.3.2.3 Restore configuration data
Dialog window: Restore configuration data
Procedure
Proceed as follows to restore a configuration database that has been backed
up manually or automatically:
1 Exit tiamo
￭ tiamo light, tiamo full
Exit tiamo.