Metrohm tiamo 2.1 Manual - Manual (Page 180)

3.8 Subwindow Live display ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
166 ￭￭￭￭￭￭￭￭ tiamo 2.1
3.7.4 Method window - Cancel command
Subwindow: Workplace ▶ Method
If a workplace is in BUSY status, then the context-sensitive menu item
Cancel can be used to stop the running of an active command immediately
and to jump directly to the next command. This applies only to commands
with live display. This cancellation is documented in the determination
(under Messages) and in the Audit Trail. The data and variables which
have already been generated by the command that was canceled will be
saved.
3.8 Subwindow Live display
3.8.1 Live display - General
Subwindow: Workplace ▶ Live display
Subwindow live display
In both of the subwindows Live display 1 and Live display 2, live curves,
measured values and messages on the method started in the run window
on the tab Single determination or Determination series are displayed.
The subwindows can be switched on in the program part Workplace during
the definition of the layout and thus made visible. They can be enlarged and
reduced as required; they can also be maximized.
The display of curves and measured values in the live window can be defined
per window and per command type in the Properties.
Tabs
The subwindows Live display 1 and Live display 2 are comprised of the
following tabs:
￭ Tracks
A tab is displayed for each track which is lettered with the name of the
track.
￭ Application note
Displaying the application message defined in the command START.
￭ Messages
Shows messages generated during a determination.
3.8.2 Live display - Tracks
Subwindow: Workplace ▶ Live display
In the subwindow Live window the main track of the method loaded
(START command) is always displayed, further tracks are only displayed if
the live display is activated in the accompanying command TRACK. A tab
is displayed for each track which is lettered with the name of the track.