Metrohm tiamo 2.1 Manual - Manual (Page 985)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 ￭￭￭￭￭￭￭￭ 971
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.CONC Concentration of the solution used for the command
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing of
the command) in the unit of the measured value
.ENP Electrode zero point calculated from the calibration
.ETE End temperature (temperature following processing of the
command) in °C
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.IME Initial measured value (measured value before start condi-
tions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions are
processed) in °C
.MTE Temperature measurement with sensor; 1 = on, 0 = off)
.RES Calculated result of the standard addition in the selected
unit
.SLO Electrode slope calculated from the calibration
.STY Type of stop with which the command was stopped: 1 =
normal;0 = manual or after error
.VAR Variance of the calculated result of the standard addition in
the selected unit
.VOL Dosed volume
5.6.4.14.2 STDADD man - General/Hardware
Tab: Method ▶ STDADD man ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the control device, the sensor and the stirrer are
defined here.