Metrohm tiamo 2.1 Manual - Manual (Page 1213)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 ￭￭￭￭￭￭￭￭ 1199
6.3.2 Backup/Restore
6.3.2.1 Backup configuration data automatically
Dialog window: Backup ▶ Configuration ▶ Data ▶ Automatically ▶ Backup config-
uration data automatically
Automatic backup
on | off (Default value: off)
If this option is switched on then the configuration database will be backed
up automatically in the defined backup directory at the required time inter-
val. The whole configuration database (including method groups and meth-
ods) is backed up.
If this option is switched off then the following parameters cannot be
edited.
Last backup
Shows the date and time of the last configuration data backup.
Next backup
Date and time at which the next backup is to be carried out. The opens
the window Next backup to select the date (see Chapter 2.5.1, page
79).
Set value Last backup + 1 month
Interval
Entry of the time interval after which an automatic backup will take place.
After each automatic or manual backup the interval entered here will be
added to the date of the Last backup and shown in the field Next
backup.
Range 1 ... 999
Default value 1
Selection Day(s) | Week(s) | Month(s) | Year(s)
Default value Month(s)
Backup directory
Selection of a pre-defined backup directory (see Chapter 6.2.3.2.1, page
1191).
Note
Make sure that you have read and write access rights on the selected
directory.