Metrohm tiamo 2.1 Manual - Manual (Page 1221)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 ￭￭￭￭￭￭￭￭ 1207
Input 1000 characters
Measured observational pairs
Table with the value pairs for Temperature and Conductivity, which were
determined for the conductivity standard. The table cannot be edited, but
with a click on the column title the temperature can be sorted according to
either increasing or decreasing sequence.
[New]
Creation of a new value pair. The window Edit value pair opens, in which
a new value pair can be entered (see Chapter 6.3.3.4.3, page 1207).
[Edit]
Edits the selected value pair. The window Edit value pair opens, in which
the value pair can be edited (see Chapter 6.3.3.4.3, page 1207).
[Delete]
Deletes the selected value pair.
6.3.3.4.3 Edit observational pair
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Conductivity stand-
ards ▶ Conductivity standards ▶ Edit conductivity standard ▶ Edit observational
pair
With [New] or [Edit] in the Edit conductivity standards dialog window,
the dialog window Edit value pair opens for entering a new value pair or
for editing an existing value pair.
Temperature
Temperature at which the conductivity was determined.
Range -20 ... 150 °C
Conductivity
Conductivity for the specified temperature (6 significant places).
Range 0.00000 ... 2000.00 mS/cm
6.3.3.5 E-mail templates
6.3.3.5.1 Manage E-mail templates
Dialog window: Configuration ▶ Tools ▶ Templates ▶ E-mail templates... ▶ E-mail
templates
The stored E-mail templates are displayed in a table in the dialog window
E-mail templates. The table cannot be edited, but with a click on the col-
umn title the table can be sorted according to the selected column in either
increasing or decreasing sequence.