Metrohm tiamo 2.1 Manual - Manual (Page 1313)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.1 ￭￭￭￭￭￭￭￭ 1299
in by the Sample Processor in order to recognize the rack. If no rack is in
position then the display will be empty.
Number of positions
Shows the number of positions on the rack. If no rack is in position then the
display will be empty.
The parameters for the rack in position are defined in the following tabs:
￭ Rack parameters
Defines the parameters that are valid for all rack positions.
￭ Lift positions
Defines the work, rinse, shift and special positions for Tower 1 and Tower
2 (if present).
￭ Special beakers
Special beaker Settings for all special beakers on the rack in position.
6.10.3.2 Properties - Rack parameters
Tab: Configuration ▶ Rack data ▶ [Edit] ▶ Properties... ▶ Rack data ▶ Rack param-
eters
Beaker radius samples
Radius of the sample beakers on the rack. If the lift is moved to the work
position then this value will be compared with the parameter Min. beaker
radius (see Chapter 7.10.3, page 1356) that can be specifically defined for
each tower. If Beaker radius samples < min. beaker radius then a cor-
responding error message will appear. With off the beaker radius will not
be checked.
Range 1.0 ... 100.0 mm
Selection off
Beaker sensor
When a sample position is moved to with the command MOVE then the
beaker sensor (Tower, Robotic arm) checks whether the special beaker is
present or not. With off no check will be made. For the option Robotic
arm a swing head with beaker sensor must be installed and a suitable work
position with beaker contact must be defined for the lift, as this must move
to the beaker recognition position.
With the parameter Beaker test in the command MOVE you can deter-
mine whether the determination is to be terminated if a beaker is missing
with or without the display of a corresponding message and whether the
series is to be continued or also terminated.
Selection Tower | Robotic arm | off