ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 131)

Communication 4-13
Installing the SIM Card
The GSM Module requires a standard SIM card provisioned for
static IP address operation to establish communication.
Since the global list of providers changes over time, as well as the
features available via the GSM infrastructure, IETG will provide
additional documentation addressing the selection and testing of
SIM cards for use with the GSM module. Please contact IETG for
specific information on procuring SIM cards for use in the specific
geographic area.
Note: When using a local account, you must reprogram
the modem to use an APN (Access Point Name). Please
contact IETG for assistance with reprogramming the
modem for use with the local carrier.
Install the SIM card in the following way:
Note: Locate the GSM module in a dry, non-hazardous
area before installing the SIM card. Do not install the SIM
card with the module attached to the monitor or damage
may occur to the monitor or the GSM module!
1. Record the number of the SIM card (i.e., the ICCID) or the IP
address (for GPRS) on the site report. You will need this
address to reconcile billing and when setting up the LIF in the
Profile or Qstart software. For AT&T SIM cards, the IP
address is printed directly on the SIM card or on a label affixed
to the card.
Example of SIM card
2. Loosen the four Phillips head screws from the clear top of the
module, and remove the top.