ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 165)

Communication 4-47
Communication cable from EMUX connected to the monitor with stretch
tape properly applied
Installing a Wireless Antenna
The EMUX supports the use of both IETG and customer-supplied
wireless antennas. Two wireless antenna options are available
through IETG: mini-wing (p/n 3800-0163) and slim (p/n 3800-
0162). Customer-supplied antennas must meet the following
specifications:
 50 ohms
 VSWR < 1:1.5
 Maximum gain of 3 dBi
 SMA male connection
Note: This is NOT a reverse-polarity connection!
Consider the following when using an IETG antenna:
 EMUX in Non-metallic Enclosure When using a non-
metallic enclosure to house the EMUX, install the antenna
completely within the enclosure:
 Secure the antenna by removing the protective tape from
the antenna and adhering the antenna to the inside wall of
the enclosure.