ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 197)

6-18 IETG FlowHawk Manual
Edit Devices dialog
4. Select the monitoring point to which you want to assign the
devices from the Monitoring Point drop-down list.
5. Select the checkboxes corresponding to the devices you want to
assign to the designated monitoring point from the Available
Devices selection box. A checkmark must display beside a
device in the Monitoring Point Devices section to ensure
Profile includes the device in the LIF. Deselect the checkboxes
corresponding to the devices you want to remove from
association with the selected monitoring point from the
Available Devices section. Profile selects the Peak Combo 1
and MLI 1 devices for the FlowHawk flow monitor by default.
Note: Because the FlowHawk allows you to connect two
of the same device type to the monitor at one time, the
Available Devices list includes two of each device type
(e.g., Peak Combo 1 and Peak Combo 2), except for the
Modem Setup device. However, do not assign two devices
of the same type to the same monitoring point. This will
cause the monitor to overwrite the new data corresponding
to one of the duplicate devices with the data from the other