ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 294)

8-10 IETG FlowHawk Manual
IETG currently offers two versions of the 12-volt battery pack for
replacing the existing battery pack in the FlowHawk, when
necessary. However, based on the date on which the monitor and/or
battery pack was manufactured, the monitor may contain an earlier
version of the 12-volt battery pack that is no longer available. The
following table describes the specific battery pack with which to
replace the existing battery pack, when the battery voltage is low or
falls below the previously specified level.
Part Number for the
Current Battery Pack
Part Number for the
Replacement Battery Pack
8000-0043 (potted with PCB) 8000-0043-01 (unpotted with PCB)
8000-0043-01 (unpotted with
PCB)
8000-0043-02 (unpotted without
PCB)
8000-0043-02 (unpotted without
PCB)
8000-0043-02 (unpotted without
PCB)
Replacing the 12-volt battery pack involves a relatively simple
process. However, this process may include an additional step or
part based on the specific type of 12-volt battery pack that requires
replacement. Replacing the battery pack in a monitor containing the
factory-installed, potted, 12-volt battery pack (p/n 8000-0043)
requires a special retainer plug (p/n 8000-0141). The plug provides
proper seating and stabilization once the monitor is reassembled
following battery pack replacement.
Replacing the battery pack in a monitor containing the unpotted, 12-
volt battery pack with a PCB (p/n 8000-0043-01) requires removal
of the PCB for reuse with the replacement battery pack (p/n 8000-
0043-02).