ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 66)

Sensor Installation and Connection 3-7
Installing the Sensors in the Pipe
This section includes the procedures for performing sensor
installations using one of the following methods:
 Standard Installations
 Special Installations
Note: When installing a monitor with wireless
communications, it is very important to test the FlowHawk
and GSM module, EMU, or EMUX with the SIM Card
installed to be sure the entire system functions and to
verify network quality of service before installation. This
check should be done before field deployment and again at
the monitoring site before installing the monitor. Refer to
Chapter 4, Communication, for more information.
Standard Installation
Performing a standard sensor installation involves the following
process:
 Gathering the parts and supplies
 Gathering the tools and equipment
 Assembling the ring
 Mounting the sensors on the ring
 Securing the cables to the ring
 Installing the ring in the pipe