ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 232)

Configuration and Activation 6-53
Temperature
The temperature sensor measures the air temperature in the pipe to
apply when calculating the speed of sound in air.
Note: Under normal conditions, the parameters in the
Temperature section should not require modification.
However, if additional adjustments are necessary, refer to
the detailed description of each parameter.
 Sensor Select the source from which to measure the
temperature used when compensating for temperature in
Ultrasonic Depth Sensor readings. The channels correspond to
the sensors connected to those channels (i.e., ports) on the
monitor. The option selected here should be consistent with the
option selected for the Channel in the Sensor section to the
left of the Temperature section.
Note: The stored temperature value is the actual air
temperature reading from the Ultrasonic Depth Sensor.
 Store Data Select this checkbox to ensure the monitor logs
the temperature data to memory. This option is selected by
default.
Editing the Modem Setup Device
The Modem Setup device only supports monitors equipped with
roaming SIM cards for wireless communication. A roaming SIM
card in a monitor modem enables the monitor to perform wireless
communication through multiple carrier networks in the vicinity of
the monitor location. This device allows you to designate the
providers that support the SIM card and offer service in the area as
well as prioritize the order in which you want the monitor to
communicate through each provider’s network. This priority should
reflect the availability, strength, reliability, and consistency of the
carrier’s signal to ensure communication.
Note: IETG strongly recommends having this device
configured by an individual with advanced knowledge in
wireless networks.