ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 373)

Modbus/EMUX Configuration and Diagnostics D-5
• Power Mode Enter 6 to toggle between the two available
power modes. The initial in parentheses (C or S) indicates the
current mode.
 Sleep Choosing this mode powers down the EMUX
following 60 seconds of inactivity. When powered down,
the LED will not be illuminated. The unit will awaken
when a request or activity occurs at one of the ports.
 Continuous Choosing this mode maintains the EMUX
in an active state, constantly scanning for inputs and
processing requests.
Modem Passthrough
Selecting this submenu enables you to interact with the modem in
the EMUX. HI indicates the unit is in passthrough mode, allowing
you to enter any commands the modem has the ability to process.
The unit does not reset automatically following a session, so make
sure the modem is in the desired mode for EMUX operation before
a time out occurs.
Hit Ctrl-C to exit passthrough mode.
The unit returns to the main menu following 3 minutes of inactivity
(i.e., no interaction between the user and the modem).
Program Modem
Selecting this submenu initiates modem programming and sets the
modem to listen mode. The modem must be in listen mode to
receive a message from another source. The programming/setting
process takes several minutes to complete. No on-screen indication
of the progress or feedback is included with this operation.
Monitor Test
Selecting this submenu sends a monitor detection query to the
monitor communication port. If a monitor is detected, a Monitor
found ID = monitor ID message will identify the monitor. If a