ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 74)

Sensor Installation and Connection 3-15
 Ultrasonic Depth Sensor Slide the Ultrasonic Depth
Sensor mounting plate onto the open end of the ring with
the back of the plate (side with the slots) facing the outside
of the ring. The side with the backstop should face the
inside of the ring. Once the mounting plate is on the ring,
the majority of the plate should be extending out from the
upstream edge of the ring.
Sliding the Ultrasonic Depth Sensor mounting plate onto the ring
6. Move the sensor mounting plate around the ring.
Note: Steps 7 and 8 apply only to overlapping rings.
Proceed directly to step 9 for non-overlapping rings.
7. Slide the open end of the ring through the slot in the welded
band of the ring until it overlaps about 102 mm.
8. Spread the ring sections apart so that you can slide the ring
stabilizer with the spreader mechanism screw into the gap.