ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 154)

4-36 IETG FlowHawk Manual
Note: If additional cable is required to cover the distance
to the DC source, select an appropriate gauge of cable to
complete the run. The existing cable is 6 millimeters (¼
in) in diameter and has an ethylene/propylene copolymer
jacket. If the cable requires splicing, use a junction box or
other method suitable for the environment in which the
cable will be installed.
10. Replace the cover onto the EMU, and securely tighten the four
plastic screws. Be sure the edges of the cover align with the
edge of the box and that no wires are trapped in the gasket.
Installing the EMU
Installing the EMU involves mounting the EMU inside the
customer-supplied enclosure, disconnecting or removing the battery
pack from the monitor (when applicable), connecting the
communication cable to the monitor, hooking up to the external
power source, and verifying the wireless signal. Perform these tasks
in the following way:
1. Mount the EMU to the panel inside the enclosure housing the
power supply using appropriate fasteners. The holes in which
the plastic screws go into to secure the cover of the EMU to the
chassis are the same holes through which the fasteners secure
the EMU to the enclosure. Therefore, it may be necessary to
remove the EMU cover to insert the fasteners through the holes
to mount the EMU to the enclosure. If this occurs, replace the
cover once the EMU is secured to the enclosure.