ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 198)

Configuration and Activation 6-19
device during data collection. In addition, IETG
recommends assigning a device to a monitoring point of
the same number. For example, assign Peak Combo 1 only
to Monitoring Point 1 and Peak Combo 2 only to
Monitoring Point 2.
Note: The Smart Depth 1 and Smart Depth 2 devices
represent stand-alone ultrasonic depth sensors.
Note: The MLI 1 and 2 and Modem Setup devices are
not associated specifically with a sensor. MLI represents
special software included in Profile (Basic Code) that is
downloaded to the monitor upon activation to support
activities such as water quality sampling and event
notification. Modem Setup represents a list of wireless
communication provider’s carrier codes.
The selected devices display in the Monitoring Point Devices
section.
6. Set or edit the parameters corresponding to each selected
device in the following way:
 Select the device you want to edit in the Monitoring Point
Devices section, and then select the Edit button.
The Edit [device type] Parameters dialog displays for the
selected device.
 Edit the device parameters. Most device dialogs include
multiple tabs representing sensors or other tools that
require editing. Refer to the following sections for details
concerning the specific parameters corresponding to each
device and any associated sensors/tools. Click on and edit
each sensor/tool tab as necessary.