ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 46)

2-10 IETG FlowHawk Manual
The connector ports located on top of the monitor can receive up to
two sensors and one communication device:
 Channel 1 and Channel 2 Ports These ports can receive
up to two of the following sensors:
 Peak Combo Sensor
 Surface Combo Sensor
 Ultrasonic Depth Sensor
 Slimline Peak Combo Sensor
Note: The channel ports on the FlowHawk receive any
combination of two sensors, including two of the same
sensor type. However, the sensors attached to the channel
ports must accurately reflect the channel assignments for
the sensor devices in Profile or Qstart. In addition, two
sensors of the same type may not be assigned to the same
monitoring point. Refer to Connecting Sensors to the
Monitor in Chapter 3, Sensor Installation and Connection,
for more information.
 COMM (Communication) Port This port supports the
following communication options:
 Wireless communications with the FlowHawk monitor
through a GSM/GPRS modem typically installed in the
manhole, an EMU installed outside the manhole adjacent
to an external power source, or an EMUX installed outside
the manhole adjacent to an RTU and/or external power
source
 Direct on-site communication with the FlowHawk monitor
through the Profile or Qstart software installed on a field
computer using a direct connect cable
The connector ports are keyed to receive only the proper sensor or
communication cables.
The FlowHawk also has an air pressure valve that exists only for
factory and maintenance testing.