ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 228)

Configuration and Activation 6-49
 Electronic Offset Enter the difference that exists between
the pressure depth readings and the value equal to the pipe
height minus the physical offset of the Surface Combo Sensor.
However, ADS recommends leaving this value at zero.
 Store Data Select this checkbox to ensure the monitor logs
pressure depth data to memory.
Temperature tab
Edit the parameters corresponding to the temperature sensor in the
Surface Combo Sensor in the same way in which you edited the
parameters for the temperature sensor in the Peak Combo Sensor.
Refer to the parameter descriptions and instructions for the
Temperature tab on page 6-31 for detailed information on the
individual parameters on the Temperature tab.
Editing the Smart (Ultrasonic) Depth Sensor
Device
Edit the following parameters corresponding to the downward-
looking ultrasonic (smart) depth sensor as necessary:
Note: Edit the parameters for an Ultrasonic Depth Sensor
equipped with the pressure option through the Surface
Combo Sensor device. Refer to Editing the Surface
Combo Sensor Device on page 6-33 for more information.