ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 69)

3-10 IETG FlowHawk Manual
Quantity Description Part Number
As needed 10mm stainless washer
15 5mm x 300mm cable tie
25 2mm x 100mm cable tie
15 4mm x 200mm cable tie
15 7mm x 400mm anchor cable tie
1 457-mm stainless steel crank handle I10–0012
1 IS pressure depth transducers (indicated by -xx- in the part number) are available
in Peak Combo Sensors, Surface Combo Sensors, and Ultrasonic Depth Sensor with
a Pressure Option in 0 - 0.34 Bar (0 - 5 psi) and 0 – 1.03 Bar (0 - 15 psi) pressure
ranges. The Peak Combo Sensor also offers a 0 - 2.07 Bar (0 - 30 psi) option.
Example: a Peak Combo Sensor with a 0 - 1.03 Bar pressure transducer would be
specified in psi: 8K-CS1-D1-15-35.
2 Extension cables can be ordered to specific lengths up to 91 meters. Note the
desired length (meters converted to feet) in the –xxx-- portion of the part number.
Standard lengths are 3.0m (10 ft.), 7.6m (25 ft.), 15.2m (50 ft.), 22.8m (75 ft.),
30.5m (100 ft.), 38.1m (125 ft.), 45.7m (150 ft.), and 61.0m (200 ft.). All other
lengths must be custom ordered.
3 Communication cables can be ordered in 3-, 26-, 30-, or 41-meter (10-, 85-, 100-,
or 135-ft.) lengths. Other cable lengths up to 91m (300 ft.) are also available by
request. Indicate the desired length in feet in the -xx- portion of the part number.
Gathering Tools and Equipment
Gather the following tools for the installation:
 Battery-powered hammer drill with assorted bits – including
the following at a minimum:
 6-mm x 150-mm masonry bit
 10-mm x 100-mm (minimum length) masonry bit
 8-mm carbide-tipped bit
 Heavy 1.5-Kg hammer
 Rubber mallet
 Carpenter’s level (approximately 610 mm in length)