Adept AdeptSight Reference Guide - Manual (Page 144)

CoordinateSystem
VPARAMETER
1000
Coordinate system used to express the results. Read only.
Syntax
MicroV+
value = VPARAMETER (sequence_id, tool_id, 1000, index_id, object_id)
V+
value = VPARAMETER ($ip, sequence_id, tool_id, 1000, index_id, object_id)
Type
Double
Range
Valu-
e Coordinate System
Name
0 hsCoordinateSystemImage
Results are expressed in pixel units with respect to the Image
coordinate system.
1 hsCoordinateSystemWorld
Results are expressed in millimeters with respect to the World
coordinate system.
2
hsCoor-
dinateSystemObject Results are expressed in millimeters with respect to the World
coordinate system.
3 hsCoordinateSystemTool
Results are expressed in pixels with respect to the Tool coor-
dinate system. This coordinate system is positioned at the
center of the Search Area of the Locator.
Parameters
$ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP
address format, for example: 192.168.1.120.
CoordinateSystem
AdeptSight Reference Guide, v3.2.x, Updated: 5/8/2012
Page 144