Rugged Cams Premier DVR - Manual (Page 75)

74
- Manual SPOT
This function is used to display the desired channel on the SPOT monitor.
Press the [MONITOR] button as in the following figure.
Then, the following figure is displayed at the right-upper side of the screen.
No mouse When moving the mouse
SPOT :
1 2 3
4 5 6
7 8 9
C 0 S
SPOT :
C – ESC
S - SELECT
If you select a channel using a number button on the remote control, The SPOT monitor setup
window disappears and the screen of the selected channel is displayed on the SPOT monitor.
„ Canceling the SPOT monitor
When the setup window is displayed as above, you can cancel the SPOT monitor view as follows even
When the SPOT monitor is not running.
1) Press the [ESC] button.
2) After 5 seconds since the window is displayed, it is cancelled.
3) After pressing 0, if you press the [SELECT] button or 5 seconds later, it is cancelled.