Rugged Cams Premier DVR - Manual (Page 90)

89
When the selection box is displayed, select the sensitivity using the direction (ST) buttons and
press the [SELECT] button.
How to set sensitivity phase
The current sensitivity phases are lowest/low/middle/high/highest and will record
determined by the % of the number of pixels against the number of total pixels.
Accordingly, you can detect much faster motion when the sensitivity is higher.
B) SENSOR
Sets the detection for input from the external sensor linked to the system.
It is allowed to set inputs from up to 16 external sensors. If there is an input signal from an external
sensor, images of the corresponding channel are recorded.
„ Sensor setup
Using the direction (STWX) buttons, move focus to the channel you want to set in the {Data
setup} Æ {Data1~4} Æ {Event}Æ{Sens.} menu and press the [SELECT] button.
To set all channels with the same value at once, move the focus to the {Sens} and press the [SELECT]
button.