Matrox MXO2 PCIe Host Adapter User Manual
Page 215
191
Defining your A/V Tools options
3
Click the
Video Capture Settings
tab.
4
From the
Input Source
list, select the type of input you want to capture. For
example, to capture material from your HDMI source, select
HDMI
.
5
From the
Input Format
list, select the video format that matches your
source video. If required, your source video will be scaled during capture to
match your editing video format. The formats available depend on your
selected input source. For information about the supported capture formats,
see
Appendix C, “Matrox MXO2 Supported Input and Capture Formats
.”
6
From the
Input Aspect Ratio
list, select the aspect ratio of your SD source
video (4:3 or 16:9). For example, to capture SD video that was recorded
using the standard TV screen format, select
4:3
. To capture SD video that
was recorded using the widescreen 16:9 format, select
16:9
. If you’re
capturing HD video, the
Input Aspect Ratio
will be set to
16:9
.
7
Under
Codec
, select the codec that you want to use for the capture.
$
Matrox 8-bit Uncompressed
Captures video to 8-bit uncompressed
format.
$
Matrox 10-bit Uncompressed
Captures video to 10-bit
uncompressed format. This is the only codec available when using a
10-bit video processing format, and is not available when using an 8-bit
format.
¦
Note
If you want to capture to a format other than
Matrox 10-bit
Uncompressed
, you can switch the video processing format (on the
General