Matrox MXO2 PCIe Host Adapter - Manual (Page 84)

60
Chapter 8, Using Matrox MXO2 with Adobe Premiere Pro
• Side-by-side Outputs horizontally compressed side-by-side 3D
video (also referred to as side-by-side horizontal).
• Over/Under Outputs over/under 3D video (also referred to as top
bottom).
¦ Note This feature may not be supported on some 3D monitors.
6 Under SDI Output , specify whether you want the format for your SDI
output to be the same as the main or secondary output.
7 Under Advanced , you can specify advanced video output settings.
$
Analog SC/H Phase Use this slider to advance or delay your analog
video output’s subcarrier phase with respect to the horizontal sync of the
genlock source (for composite video only).
$
Allow Super White/Allow Super Black Select Allow Super White
to allow the highest luminance level of your video output to exceed the
standard maximum white level. Select
Allow Super Black to allow the
lowest luminance level of your video output to fall below the standard
black level. These options apply to all video outputs.
¦ Note Super white and super black should not be allowed when producing
your final video production for broadcast.
8 Under Video Bit Depth , select either 8-bit or 10-bit to indicate the bit
depth that you want for your video output.
¡ Important Only 10-bit uncompressed clips without effects or with
GPU-accelerated effects, and video previews that have been rendered using
the Matrox 10-bit uncompressed codec can be output at 10-bit. For more
information about using this feature, see
“About the Matrox 10-bit editing
workflow” on page 55 .
9 Click OK to save your settings.