Fortinet 548B - Manual (Page 280)

- 280 -
Syntax
sntp multicast client poll-interval <poll-interval>
no sntp multicast client poll-interval
<poll-interval> - Polling interval. It ’s 2^(value) seconds where the range of value is 6 to 10.
no – This command will reset the poll interval for SNTP multicast client to its default value.
Default Setting
The default value is 6.
Command Mode
Global Config
7.11 MAC-Based Voice VLAN Commands
7.11.1 Show Commands
7.11.1.1 show voice-vlan
This command uses to display the configuration status of the Voice VLAN on the switch.
Syntax
show voice-vlan
Default Setting
None
Command Mode
Privileged Exec
Display Message
Vlan Voice-Vlan status: The voice-vlan status (Enable/Disable).
Voice-Vlan ID: The specified VLAN to vloce vlan.
Voice Name: The voice-name is the name of the voice device, which is to help the device
management.