Fortinet 548B - Manual (Page 507)

- 507 -
9.2.2.9 ip igmp startup-query-interval
This command sets the interval between General Queries sent by a Querier on startup on the interface.
The time interval value is in seconds.
Syntax
ip igmp startup-query-interval <1-300>
no ip igmp startup-query-interval
<1-300> - The range for <1-300> is 1 to 300 seconds.
no - This command resets the interval between General Queries sent by a Querier on startup on the
interface to the default value.
Default Setting
31
Command Mode
Interface Config
9.3 MLD Commands
This section provides a detailed explanation of the MLD commands. The commands are divided into the
following different groups:
Show commands are used to display device settings, statistics and other information.
Configuration commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
9.3.1 Show Commands
9.3.1.1 show ipv6 mld groups
Use this command to display information about multicast groups that MLD reported. The information is
displayed only when MLD is enabled on at least one interface. If MLD was not enabled on even one
interface, there is no group information to be displayed.
Syntax
show ipv6 mld groups {<slot/port> | <group-address>}
Default Setting
None