Fortinet 548B - Manual (Page 296)

- 296 -
no lldp transmit-mgmt
no - This command is used to cancel inclusion of the management information in LLDPDUs.
Default Setting
None
Command Mode
Interface Config
7.12.2.6 lldp transmit-tlv
This command is used to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs. Use sys-name to transmit the system name TLV. To
configure the system name, please refer to
“snmp-server” command. Use sys-descto transmit the
system description TLV. Use sys-cap to transmit the system capabilities TLV. Use port-desc to transmit
the port description TLV. To configure the port description, please refer to
“description” command. Use
org-spec to transmit the organization specific TLV.
Syntax
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc] [org-spec]
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc] [org-spec]
no - This command is used to remove an optional TLV from the LLDPDUs. Use the command
without parameters to remove all optional TLVs from the LLDPDU.
Default Setting
None
Command Mode
Interface Config
7.12.2.7 lldp timers
This command is used to set the timing parameters for local data transmission on ports enabled for
LLDP. The <interval-seconds> determines the number of seconds to wait between transmitting local
data LLDPDUs. The range is 1-32768 seconds. The <hold-value> is the multiplier on the transmit
interval that sets the TTL in local data LLDPDUs. The multiplier range is 2-10. The <reinit-seconds> is
the delay before re-initialization, and the range is 1-0 seconds.