Fortinet 548B - Manual (Page 583)

- 583 -
<no> - This command sets the default OSPF retransmit Interval for the specified interface.
Default Setting
5
Command Mode
Interface Config
10.4.2.10 ipv6 ospf transmit-delay
This command sets the OSPF Transit Delay for the specified interface. The transmit delay is specified in
seconds. In addition, it sets the estimated number of seconds it takes to transmit a link state update
packet over this interface. Valid values for <seconds> range from 1 to 3600 (1 hour).
Syntax
ipv6 ospf transmit-delay <seconds>
no ipv6 ospf transmit-delay
<no> - This command sets the default OSPF Transit Delay for the specified interface.
Default Setting
1
Command Mode
Interface Config
10.4.2.11 ipv6 router ospf
Use this command to enter Router OSPFv3 Config mode.
Syntax
ipv6 router ospf
Default Setting
None
Command Mode
Global Config