Fortinet 548B - Manual (Page 297)

- 297 -
Syntax
lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit <reinit-seconds>]
no lldp timers [interval] [hold] [reinit]
<interval-seconds> - Configures the number of seconds to wait between transmitting local data
LLDPDUs
<hold-value> - Configures the multiplier on the transmit interval that sets the TTL in local data
LLDPDUs
<reinit-seconds> - Configures the delay before re-initialization
no - This command is used to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Default Setting
Interval-seconds 30
Hold-value 4
Reinit-seconds 2
Command Mode
Global Config
7.12.2.8 lldp tx-delay
This command is used to set the timing parameters for data transmission delay on ports enabled for
LLDP. The <delay-seconds> determines the number of seconds to wait between transmitting local data
LLDPDUs. The range is 1-8192 seconds.
Syntax
lldp tx-delay <delay-seconds>
no lldp tx-delay
no - This command is used to return return the transmit delay to the default value.
Default Setting
2
Command Mode
Global Config