Fortinet 548B - Manual (Page 465)

- 465 -
8.3.2.44 ip ospf transmit-delay
ip ospf transmit-delay command sets the OSPF Transit Delay for the specified interface. The transmit
delay is specified in seconds. In addition, it sets the estimated number of seconds it takes to transmit a
link state update packet over this interface. Valid values for <seconds> range from 1 to 3600 (1 hour). no
ip ospf transmit-delay command sets the default OSPF Transit Delay for the specified interface
Syntax
ip ospf transmit-delay <1-3600>
no ip ospf transmit-delay
Default Setting
1
Command Mode
Interface Config
8.3.2.45 ip ospf mtu-ignore
ip ospf mtu-ignore command disables OSPF maximum transmission unit (MTU) mismatch detection.
OSPF Database Description packets specify the size of the largest IP packet that can be sent without
fragmentation on the interface. When a router receives a Database Description packet, it examines the
MTU advertised by the neighbor. By default, if the MTU is larger than the router can accept, the
Database Description packet is rejected and the OSPF adjacency is not established. no ip ospf
mtu-ignore command enables the OSPF MTU mismatch detection.
Syntax
ip ospf mtu-ignore
no ip ospf mtu-ignore
Default Setting
Enabled
Command Mode
Interface Config
8.3.2.46 router-id
router-id command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id. The
<ipaddress> is a configured value.