16 static mac filtering commands, 1 show commands, 1 show mac-address-table static – Fortinet 548B User Manual
Page 318: Static mac filtering commands
- 318 -
Default Setting
None
Command Mode
Global Config
This command uses to add an interface to a protected port group. The <groupid> parameter
identifies the set of protected ports to which this interface is assigned. You can only configure
an interface as protected in one group.
Syntax
switchport protected <0-2>
no switchport protected <0-2>
no - This command uses to configure a port as unprotected.
Default Setting
None
Command Mode
Interface Config
7.16
Static MAC Filtering Commands
7.16.1 Show Commands
7.16.1.1 show mac-address-table static
This command displays the Static MAC Filtering information for all Static MAC Filters. If you select <all>,
all the Static MAC Filters in the system are displayed. If you supply a value for <macaddr>, you must
also enter a value for <vlanid>, and the system displays Static MAC Filter information only for that MAC
address and VLAN.
Syntax
show mac-address-table static {<macaddr> <1-3965> | all}
<macaddr> - Static MAC address.