Fortinet 548B - Manual (Page 467)

- 467 -
Command Mode
Router OSPF Config Mode
8.3.2.49 passive-interface default
passive-interface default command to enable global passive mode by default for all interfaces. It
overrides any interface level passive mode. OSPF will not form adjacencies over a passive interface. no
passive-interface default command to disable the global passive mode by default for all interfaces. Any
interface previously configured to be passive reverts to non-passive mode.
Syntax
passive-interface default
no passive-interface default
Default Setting
Disabled
Command Mode
Router OSPF Config Mode
8.3.2.50 passive-interface
passive-interface command to set the interface or tunnel as passive. It overrides the global passive
mode that is currently effective on the interface or tunnel. no passive-interface command to set the
interface or tunnel as non-passive. It overrides the global passive mode that is currently effective on the
interface or tunnel..
Syntax
passive-interface {<slot/port> | tunnel <tunnel-id>}
no passive-interface {<slot/port> | tunnel <tunnel-id>}
Default Setting
Disabled
Command Mode
Router OSPF Config Mode
8.3.2.51 timers spf
Use this command to configure the SPF delay time and hold time. The valid range for both parameters is
0-65535 seconds..