Fortinet 548B - Manual (Page 63)

- 63 -
<macaddr> - enter a MAC Address to display the table entry for the requested MAC address.
Default Setting
None
Command Mode
Privileged Exec
Display Message
MAC Address: A unicast MAC address for which the switch has forwarding and/or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that are separated by colons, for
example 01:23:45:67:89:AB. In an IVL system the MAC address will be displayed as 8 bytes. In an
SVL system, the MAC address will be displayed as 6 bytes. Note: This software version only
supports IVL systems.
VLAN ID: There is a VLAN Identifier (VID) associated with each VLAN. The range of the VLAN ID is
1 to 3965.
7.2.3.4 show vlan association subnet
This command displays the VLAN associated with a specific configured IP-Address and net mask. If no
IP Address and net mask are specified, the VLAN associations of all the configured IP-subnets are
displayed.
Syntax
show vlan association subnet [<ipaddr> <netmask>]
<ipaddr> - The IP address.
<netmask> - The subnet mask.
Default Setting
None
Command Mode
Privileged Exec
Display Message
IP Subnet: The IP address assigned to each interface
IP Mask: The subnet mask.
VLAN ID: There is a VLAN Identifier (VID) associated with each VLAN. The range of the VLAN ID is
1 to 3965.
7.2.3.5 show protocol group
This command displays the Protocol-Based VLAN information for either the entire system, or for the
indicated Group.