Fortinet 548B - Manual (Page 411)

- 411 -
7.25.2.4 ip domain-list
This command defines the domain name that can be appended to incomplete host names (i.e., host
names passed from a client are not formatted with dotted notation). The domain name table can contain
maximum 6 entries.
Syntax
ip domain-list <name>
no ip domain-list <name>
<name> - Default domain name used to complete unqualified host names. Do not include the initial
period that separates an unqualified name from the domain name. (Range: 1-64 characters)
i
When an incomplete host name is received by the DNS server on this switch, it will work
through the domain name list, append each domain name in the list to the host name, and
check with the specified name servers for a match. If there is no domain name list, the domain
name specified with the "ip domain-name" command is used. If there is a domain name list,
the default domain name is not used.
Default Setting
None
Command Mode
Global Config
7.25.2.5 ip name-server
This command specifies the address of one or more domain name servers to use for name-to-address
resolution. There are maximum 6 entries for IPv4 and 6 entries for IPv6 in the Domain Name Server
Table.
Syntax
ip name-server <ipaddr>
no ip name-server <ipaddr>
< ipaddr > - IP address of the Domain Name Servers.
<no> - Remove the corresponding Domain Name Server entry from the table.
Note - The listed name servers are queried in the specified sequence until a response is received, or
the end of the list is reached with no response.
Default Setting
None
Command Mode
Global Config