Fortinet 548B - Manual (Page 490)

- 490 -
no ip vrrp <1-255> preempt
<1-255> - The range of virtual router ID is 1 to 255.
<no> - This command sets the default preemption mode value for the virtual router configured on a
specified interface.
Default Setting
Enabled
Command Mode
Interface Config
8.8.2.6 ip vrrp priority
This command sets the priority value for the virtual router configured on a specified interface.
The router with the highest priority is elected master. If a router is configured with the address used as
the address of the virtual router, the router is called the "address owner". The priority of the address
owner is always 255 so that the address owner is always master. If the master has a priority less than
255 (it is not the address owner) and you configure the priority of another router in the group higher than
the master's priority, the router will take over as master only if preempt mode is enabled.
Syntax
ip vrrp <1-255> priority <1-254>
no ip vrrp <1-255> priority
<1-255> - The range of virtual router ID is 1 to 255.
<1-254> - The range of priority is 1 to 254.
<no> - This command sets the default priority value for the virtual router configured on a specified
interface.
Default Setting
The default priority value is 100 unless the router is the address owner, in which case its priority is
automatically set to 255.
Command Mode
Interface Config
8.8.2.7 ip vrrp timers advertise
This command sets the advertisement value for a virtual router in seconds.