Fortinet 548B - Manual (Page 566)

- 566 -
10.3.2.21 ipv6 neighbors static
The user can add/delete a static neighbor into neighbor cache table.
Syntax
ipv6 neighbors static <ipv6-address> <mac-address>
no ipv6 neighbors static <ipv6-address>
<ipv6-address> - Enter the IPv6 Address.
<mac-address> - Enter the MAC Address.
no – This command sets IPv6 neighbor configuration to default values.
Default Setting
None
Command Mode
Global Config
10.4 OSPFv3 Commands
This section describes the commands you use to configure OSPFv3, which is a link-state routing
protocol that you use to route traffic within a network.
10.4.1 Show Commands
10.4.1.1 show ipv6 ospf
This command displays information relevant to the OSPF router.
Syntax
show ipv6 ospf
Default Setting
None
Command Mode
Privileged Exec
Display Messages
NOTE: Some of the information below displays only if you enable OSPF and configure certain
features.