Fortinet 548B - Manual (Page 593)

- 593 -
10.4.2.30 distance ospf
This command sets the route preference value of OSPF in the router. Lower route preference values are
preferred when determining the best route. The type of OSPF can be intra, inter, type-1, or type-2. The
OSPF specification (RFC 2328) requires that preferences must be given to the routes learned via OSPF
in the following order: intra < inter < type-1 < type-2. The <preference> range is 1 to 255. A route with a
preference of 255 cannot be used to forward traffic.
Syntax
distance ospf {intra | inter | type1 | type2} <preference>
no distance ospf {intra | inter | type1 | type2}
<preference> - The range for intra is 1 to 252. The range for inter is 2 to 253. The range for type1 is
3 to 254. The range for type2 is 4 to 255.
no - This command sets the default route preference value of OSPF in the router.
Default Setting
Intra is 8.
Inter is 10.
Type 1 is 13.
Type 2 is 150.
Command Mode
Router OSPFv3 Config
10.4.2.31 enable
This command resets the default administrative mode of OSPF in the router (active).
Syntax
enable
no enable
<no> - This command sets the administrative mode of OSPF in the router to inactive.
Default Setting
Enabled
Command Mode
Router OSPFv3 Config