Fortinet 548B - Manual (Page 814)

- 814 -
Simple - a route will not be included in updates sent to the router from which it was learned.
Poisoned reverse - a route will be included in updates sent to the router from which it was
learned, but the metric will be set to infinity.
The default is simple.
Auto Summary Mode - Select enable or disable from the pulldown menu. If you select enable
groups of adjacent routes will be summarized into single entries, in order to reduce the total number
of entries. The default is disabled.
Host Routes Select Mode - Select enable or disable from the pulldown menu. If you select enable
the router will be accept host routes. The default is enabled.
Default Information Originate - Enable or Disable Default Route Advertise.
Default Metric - Sets a default for the metric of redistributed routes.This field displays the default
metric if one has already been set or blank if not configured earlier. The valid values are 1 to 15.
Non-Configurable Data
Global Route Changes - The number of route changes made to the IP Route Database by RIP.
This does not include the refresh of a route's age.
Global queries - The number of responses sent to RIP queries from other systems.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.4.5.2 Viewing Each Routing Interface’s RIP Configuration Page
Non-Configurable Data
Slot/Port - The slot and port for which the information is being displayed.
IP Address - The IP Address of the router interface.
Send Version - The RIP version to which RIP control packets sent from the interface conform. The
value is one of the following:
RIP-1 - RIP version 1 packets will be sent using broadcast.
RIP-1c - RIP version 1 compatibility mode. RIP version 2 formatted packets will be transmitted
using broadcast.
RIP-2 - RIP version 2 packets will be sent using multicast.
None - RIP control packets will not be transmitted.